Description
The DynaGen™ TG410 is a generator controller that supports three-phase voltage and current metering for generator applications. It provides autostart operations for mechanically or electronically governed engines and has a Modbus port with galvanic isolation to connect remote annunciators and internet monitoring devices.
The controller has nine inputs and six outputs. It is ideally suited for mobile or stationary equipment where reliability is critical.
Housing
-
- Conformally coats for protection against moisture and contaminants
- Front panel gasket for panel water ingress protection
Display
-
- Oil pressure and engine temperature
- Fuel and oil levels
- Hour meter
- RPM
- Battery voltage
- Real-time clock with date/time
- J1939 DTC codes
- DPF and DEF status icons
- J1939 percent load and percent torque
- Custom screens for pumping or compressor applications
- Power factor, apparent power, real power, and reactive power metering for generator applications
Autostart
Autostart on low battery, automatic shutdown and warnings, manual and remote start, and autostart trigger on sensor value (pressure, temperature, level voltage)
Functions
-
- Built-in weekly scheduler
- Maintenance counter
- Preheat and many configurable timers
- Stall detection
- Retry on a false start
- Custom warnings and failures
- Configurable Diagnostic Trouble Code (DTC)
- Load imbalance detection
- IDMT overcurrent protection
- Exercise clock
- 150 event logs
Speed Control
-
- Speed control offset adjustment for electronic engines
- RPM via J1939
- Magnetic pick-up
- Configurable setpoint RPM output feature
Closed Loop Control
Closed loop control on custom senders
Communications
-
- CANbus J1939
- RS-485
Inputs / Outputs
Four analog inputs, five digital inputs, and six switched outputs
ISO Certification
Manufactured in an ISO 9001:2015 certified operation
Reload document 
Open in new tab 
